1. Determine the area to which the system will be attached.
2. Degrease with alcohol this area and edges of the system mesh or its silicone edge. It is good to use a tread for oily scalp – it increases the lifetime of glue and adhesive strips. It also prevents softening of the glue by sweat and grease. Try the system on the head and attach the top to a tape or glue as convenient so that it does not skew. The system’s hair should be in the tail and the edges of the hair should be clamped with pins or clips so that it does not get on the glue and under the system.
3. Then apply glue to the scalp and wait 1.5 – 2 minutes for it to dry up a little (this is very important!). Until it is liquid it can leak through the mesh to the hair. Then press it firmly to your head for 30 seconds and do nothing for 7-10 minutes – let the glue grip. The glue stretches and the brush or tube should be taken away from the place of gluing in sharp movements to prevent it from being applied to everything around. Before washing, the system should be turned inside out, the base should be washed, then turned out and put on the dummy, and only then washed outside.
Preparation for washing.
Before washing the system, gently brush the hair using fluids and remove all nodules, as it is very difficult to do it after washing. When brushing, avoid contact with the base of the system.
Rinsing.
Rinse the system with cold water, watering it from the roots to the hair tips. Use a balm. To preserve the natural appearance of natural hair and make it silky, be sure to use high quality balms and moisturizing masks. BALM IS NOT APPLIED TO THE ROOTS (TOP) OF THE SYSTEM, ONLY RETREATING 10 CM!
Drying.
Wrap the wet system in a dry towel and squeeze it gently. Dry on the towel at room temperature. Do not speed up the drying process by placing the product close to heat sources, as this may result in deformation of the system and hair loss.
Hairstyling.
Don’t brush wet hair. Shake and brush gently almost dry system using special fluids. Start from the hair tips and move gradually to the roots. Then place it on a special dummy head, and with a brush with wide teeth give the product the desired shape. You can also use all sorts of irons and curlers.
The system can’t be exchanged or returned!!!
EN 
RU 
FR 
UA 
ES 
+1 (650) 656 6119
+380 (50)
182 78 90
